Cooper Security 9751 Guia do Utilizador descarregar pdf (Página 39)

4. Programming

496929 Page 37

4. Key in the two digits for the month number and press Y . Use a leading

zero for January to September.

5. Key in the two digits of the year and press Y.

The display shows the current time, for example:

H09 M15

6. Key in two digits for the hours of the day and press Y. Use the 24-hour

clock.

7. Key in two digits for the minutes and press Y.

The keypad sounder gives a double “bleep” and the display shows

“Installer Mode”. The system sets its internal clock/calendar to the time

you have given it.

52: Omit Tamper Allowed

This Command ensures that the control unit omits the tamper contacts as well

as the alarm contacts when a user omits a zone.

Note: You must give the zone the omit attribute to allow the user to omit a

zone.

Option

0 The control unit omits alarm contacts only

1 The control unit omits both alarm and tamper contacts when the user

omits a zone.

53: Abort Reset

Option

0 Ensures that reset after abort is the same as system reset (see

Command 33).

1 Enables customer reset after an abort.

60: Level B Final Exit Operation

Command 60 controls how the system will treat Final Exit zones in part set

Level B. When the Command option is set to 0 any Final Exit zones included

in part set B will continue to act as Final Exit zones during part set B. When

the option is set to 1 any Final Exit zones included in part set B will act as

Normal Alarm zones during part set B.

61: Level B Entry Route Response

Command 61 controls how the system treats Entry Route zones during part

set B. When the option is set to 0 all Entry Route zones included in part set B

will continue to act as Entry Routes during part set B. When the option is set

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 55 56

Sem comentários

Cooper Security 9751 Guia do Utilizador Página 39