Cooper Security i-on 16 Manual de Instalação

CT-Interface & IRIS Touch 600 Range Installation Manual Coopers I-ON Panel Range Version 2.0

Page 10 of 16 3.14 I-ON Panel Configurations Now configure the panel using the guide below and with the correct information supplied for the site

Page 11 of 16 IRIS Touch Configuration & Testing Reconnect the IRIS Dialler Configuration and select and connect, and then continue on the welcom

Page 12 of 16 3. Select “Installers Menu” and enter the default installer code “111111” and press “OK”.  Note: On the IRIS Touch welcome

Page 13 of 16 11. The IRIS Touch will now perform tests over the Ethernet path to confirm polling and alarm are being received by the monitoring c

Page 14 of 16 4 Communication trouble reporting The IRIS Touch 600 range simulates the Coopers 8750 Ethernet module, but allows for dual path commu

Page 15 of 16 5 Appendix B – Specification Ethernet Interface 10Mbps and 100Mbps (10/100BaseT) with auto-negotiation UTP with standard RJ45 socket f

Page 16 of 16 Telephone: +44 (0)118 988 0228 E: [email protected] www.chironsc.com Chiron Security Communications Ltd, Wyvols Court, Swallowfield

Page 2 of 16 Table of Contents 1 System Overview ... 3 2 IRIS

Page 3 of 16 1 System Overview The Chiron IRIS Touch range of communicators offers a way of transmitting alarm signals to an monitoring centre over

Page 4 of 16 3 Connections for Coopers I-ON Panel & IRIS Touch Please follow the following steps to install and configure the communicator. 3.1

Page 5 of 16 3.4 Plug on the CT-Interface board as show in the image 3.5 Plug the IRIS Touch onto the CT-Interface board For panel versions where

Page 6 of 16 3.6 Connect the Ethernet cable (Ethernet / IP connections) [2] Ethernet cable supplied in the box or any standard Cat5 Ethernet cable.

Page 7 of 16 3.10 Once you have connected go to the Remote Touch Screen Tab 3.11 Perform GPRS Network scan (IRIS Touch 640 only)  Note: The GSM

Page 8 of 16 It is recommended that you try the antenna in a number of locations around the IRIS Touch installation, to find the best signal strengt

Page 9 of 16 2. Follow the next set of screen to configure up the IRIS Touch Emulation mode Once you have selected the RS232 Cooper