Cooper Security i-onEX Manual do Utilizador

FOB-2W-4B Page 8 8. Press any button on the remote control that you wish to register. Hold the button down until you see the transmit LED flash.

FOB-2W-4B Page 9 4. Deleting Fobs From the System If you have lost a fob assigned to you then you should delete it from the system to make sure that n

FOB-2W-4B Page 10 11. Press  until the bottom line of the display shows the remote you wish to delete. 12. Press 

FOB-2W-4B Page 11 5. Changing the battery. If you have had the fob for some time and the battery has run low, then you will need a 3V CR2450 LiMn02 ty

FOB-2W-4B Page 12 7. Tighten the screw until it holds the battery lid closed. Do not over-tighten the screw. 8. Test the new battery by holding do

FOB-2W-4B Page 13 6. Technical Specifications General Product number FOB-2W-4B. Product Description Keyfob 2 way 4 button. Manufacturer Cooper Securit

FOB-2W-4B Page 14 Security Security Grade Grade 2 Digital key differs 16,777,216 (224) Note: Prolonged and continuous use at temperatures below 5°

FOB-2W-4B Page ii Contents 1. Introduction ... 1 Fitting the Battery ...

FOB-2W-4B Page 1 1. Introduction The two-way keyfob, FOB-2W-4B, is a remote control designed to give you confidence that your alarm system has set or

FOB-2W-4B Page 2 2. Lift off the battery lid. 3. Fit the new battery. The positive side of the battery should be on top. Note: make sure your hand

FOB-2W-4B Page 3 Operating the buttons To ensure that the fob does not accidentally operate while it is in your pocket, the buttons are deliberately s

FOB-2W-4B Page 4 2. Using the Fob Setting the System Press and hold: The setting LED flashes red three times. The system sets. The control uni

FOB-2W-4B Page 5 Unsetting the System Press and hold: The un-setting LED flashes red three times. The system unsets. The unset LED glows green

FOB-2W-4B Page 6 control unit then sends a message to the fob to confirm that it has started a PA alarm. All four LEDs glow green for three seco

FOB-2W-4B Page 7 3. Registering Fobs on the System You can register a fob on the alarm system yourself (provided you are not a “Guard” or “Set Only” u