Cooper Security i-on160EX Manual do Utilizador descarregar pdf (Página 37)

i-on40 & i-onEX Range 3. Setting and Unsetting

Page 31

Override by:

Message

Meaning

Grade 2

Grade 3



An expander or keypad

has a fault, or the

cabling between parts of

the system has a fault.

Installer



The AC supply has

stopped for more than

10 seconds.

User



The back-up battery has

a problem.

User or

Installer





Part of the

communication system

has a problem.

User or

Installer



The system has

detected a fault not

covered by the above

categories.

User

Your system may be programmed so that only the Installer

can override this fault.

Unsetting the System Using a Keypad

When unsetting the system do not stray from the entry route

designated by the installer. If you do so then you will cause an

alarm.

Start the Entry Procedure

Do this:

The display shows:

1. Enter by the designated entry

door or route. (This usually

the last through which you

leave the premises.)

Go directly to the keypad.

The system starts the entry

timer. The keypad sounds the

entry tone (an interrupted

tone).





1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 121 122

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Manual do Utilizador Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX