Cooper Security i-on 16 Guia do Utilizador descarregar pdf (Página 16)

i-on30EX

Page 12

The jumpers have the following functions:

ON

BRIGHT

BL

ABCD-ON

ON

BRIGHT

BL

ON

BRIGHT

BL

ABCD-ON

The set/unset LEDs are disabled.

ON

BRIGHT

BL

ABCD-ON

ON

BRIGHT

BL

ON

BRIGHT

BL

ABCD-ON

The set/unset LEDs shows the setting

status of the system. (Full set is the left

hand LED.)

ON

BRIGHT

BL

ABCD-ON

ON

BRIGHT

BL

ON

BRIGHT

BL

ABCD-ON

The key backlights are disabled. They

will glow briefly for five seconds when a

user presses a key.

ON

BRIGHT

BL

ABCD-ON

ON

BRIGHT

BL

ON

BRIGHT

BL

ABCD-ON

The key backlights glow all the time at

normal intensity.

ON

BRIGHT

BL

ABCD-ON

ON

BRIGHT

BL

ON

BRIGHT

BL

ABCD-ON

The keypad backlights glow all the time,

extra bright.

Tone Volume

To alter the volume of non-alarm tones

from the keypad adjust the keypad sounder

volume control (2 in Fig 7):

Louder

Note: This control changes

the volume of non-alarm

tones (for example

Exit/Entry tone). The volume

of alarm tones is fixed.

Softer

Engineering Keypad

An Engineering Keypad is a modified i-kp01

that can be plugged into a dedicated

connector on the control unit pcb (see 17

on Figure 2) or any of the expanders (see

13 on Figure 8 or 10 on Figure 9). An

Engineering Keypad does not need to be

addressed, and will always be recognised

by the control unit.

You can use an Engineering Keypad to

program the system without being tied to

any of the installed keypads. If you wish to

move an Engineering keypad from one

connection point to another then you can

do so without removing power from the

system.

Step 4. Fit and Connect

Expanders

Both wired and radio expanders are

supplied in the same plastic case. Use M4

25mm countersunk screws in at least three

fixing holes when mounting the back of the

case on the wall. See Figures 8 or 9 for the

position of fixing holes and cable entries.

Connecting an Expander to the Bus

Both wired and radio expanders provide a

connector for the bus at the bottom of their

pcbs (item 4 on Figures 8 and 9 ) .

Figure 14 Wiring Expanders

Addressing Expanders

The control unit assigns addresses to all

devices connected to the bus cable. You

must start this process off once all bus

devices are connected, during the initial

power up. See page 20 for instructions.

Expander Loudspeakers

During normal operation loudspeakers on

expanders repeat setting and entry tones

for the partition that the expander is

allocated to. During an alarm the

loudspeakers repeat alarm tones.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comentários a estes Manuais

Sem comentários