Cooper Security M2000 Guia do Utilizador descarregar pdf (Página 96)

Engineer Menu 1-9 Engineering Manual

Mimic, Set only – When using an output of type Mimic, the output mimics the zone only if

the zone is in a ward that is set. The output mimics the zone, even if the zone is omitted or

shunted (e.g. using User option 1-2 or 1-3; see the

Manager's Manual

23 – Lo Security Eng. / Hi Security Eng.

Lo Security Eng. – You are able to access the Engineer menu options by entering the

engineer code.

Hi Security Eng. – When you enter the engineer code, a code is displayed. You need to

contact the Alarm Receiving Centre (ARC) and tell them the code to obtain a remote reset

code. Entering the remote reset code then gives access to the Engineer menu options.

24 – Duress Allow NO / Duress Allow YES

Duress Allow NO – Prevents Duress and Panic user codes from being set up in User option

2-4.

Duress Allow YES – Enables Duress and Panic user codes to be set up in User option 2-4

(please refer to the

Manager's Manual

25 – Keypad PA OFF. / ON

Keypad PA OFF – Switches off the keypad PA feature, as described next.

Keypad PA ON – Causes an audible panic alarm to be generated when keys 1 and 3 keys

are simultaneously pressed at the keypad.

26 – P.Set Hotkey YES/ P.Set Hotkey NO

P.Set Hotkey YES – Enables ward group hot keys to be used to part set/unset the system

(see the

Manager's Manual

P.Set Hotkey NO – Prevents ward group hot keys from being used.

Note: Select P.Set Hotkey NO to allow users to perform silent set using key

27 – Exit Foyer / Inst Set Foyer

Exit Foyer – Causes ward 1 always to use the ward 1 Exit time (page 60) whenever the ward

is set automatically by the Foyer Mode option (page 37).

Inst Set Foyer – Allows ward 1 to ignore the Exit Delay and set instantly when all wards

specified by the Foyer Mode option have been set. This can occur only if the keypad or

keyswitch (page 24) used to set the last ward is not in ward 1.

28 – Unset Entry Wards/Unset All Wards

This option applies to telecommand unset buttons (button 4) that are allocated to more

than one ward. Note that this option works in conjunction with option 1-3-2-15

Entry Unset. A ward must be listed in Option 1-3-2-15 before Option 1-9-1-

28 has any effect.

Unset Entry Wards – A telecommand will unset the ward that has an entry timer running

(or is in alarm), but leave unchanged any other ward that is set (and allocated to the

telecommand unset button).

Unset All Wards – A telecommand will unset all wards allocated to the unset button when

any one of the wards has an entry timer running (or is in alarm).

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security M2000 Guia do Utilizador Página 96

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security M2000