Cooper Security i-on16 Guia de Instalação descarregar pdf (Página 21)

i-on16 2. Alarms

Page 21

alerts the keypad will return to

its‟ standby screen and, after

a few seconds, the rim of the

navigation pad will glow

green. In addition the keypad

will stop beeping.

OR: Press . The rim of the

navigation pad will stay red and

the system will show the text of

the alert the next time you key in

an access code. (The keypad will

stop beeping.)

Note: 1. The system will not alert you to short (less than 10s)

interruptions of mains power. If the cause of an alert goes

away, then the system will remove the Alert message.

2. The system records all alerts in the log, with the time

when you acknowledged them.

If you wish to set the system while a fault is present please go to

page 27.

Technical Alarms

Your alarm system may be fitted with a “technical alarm” zone.

This type of alarm is NOT designed to alert you of a fire, burglary

or personal attack but can be used, for example, to monitor the

temperature of freezers, or the health of other equipment.

When a technical alarm occurs the control unit makes the rim of

the navigation pad glow red, and the keypad will give a short

“beep” every few seconds, exactly as for an Alert.

You can silence the beeping tone by following steps 1 to 4 on

page 20. When you key in your access code the bottom line of

the display will show, for example “Tech Z016 Alarm” to indicate

that the cause of the beeping is a technical alarm. (Press  or 

to see the zone name, if one has been programmed.)

Note that if the technical zone detector is still active when you try

to reset the system then the keypad will show the message

“RESET FAULTS”. You must make sure that the detector is not

active before you can reset a technical alarm.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 89 90

Sem comentários

Cooper Security i-on16 Guia de Instalação Página 21