Cooper Security i-on16 Guia de Instalação descarregar pdf (Página 7)

i-on16

Page 7

1. Introduction

The i-on16 is a wireless intruder alarm system intended mainly

for use in domestic and small commercial properties.

The heart of the i-on16 system is the control unit and its keypad.

The control unit contains the main wireless receiver, the power

supply and stand-by battery. The stand-by battery can keep the

alarm system going for up to 12 hours if the mains supply fails.

Connected to the control unit by cable are the keypads. The

keypads each have a two line display to show you status

information, and various keys for operating the system. The

keypads also contain a speaker to give warning tones when the

system is setting or unsetting.

Users identify themselves to the system by keying in access

codes. If they do not wish to use access codes then the keypads

also contain proximity tag readers, allowing users to identify

themselves by means of small electronic tags that they carry with

them.

To protect an area the control unit can operate a range of

detectors. Detectors can be connected to the control unit or

expanders by wires, or communicate to a radio expander using a

small radio transmitter. Figure 1 shows some examples. In

addition to fixed detectors the control unit can also monitor small

portable transmitters that users can employ to start alarms

remotely, for example in the case of a Hold Up Alarm.

(Hold Up Alarms are also known as Panic Alarms.)

When the control unit detects an alarm, it can start an external

sounder/strobe unit by sending the appropriate radio signal. In

addition the control unit can also communicate using a variety of

plug on modules. Some modules also provides speech recording

and playback facilities so that the system can send recorded

speech messages to pre-programmed telephone numbers.

The control unit and expanders also provide sets of connectors for

outputs, which the installer can use to link the control unit to

siren/strobe units or other equipment.

1 2 3 4 5 6 7 8 9 10 11 12 ... 89 90

Sem comentários

Cooper Security i-on16 Guia de Instalação Página 7