Cooper Security i-on40 Manual do Utilizador descarregar pdf (Página 31)

i-on40 Administration

Page 27

Note: You can switch the output on and off from the Menu by

selecting Outputs On/Off (see page 31).

If you want to program a telecommand to control the

output, see page 27.

Programming Remote Controls for Users

The System Config - Remotes option allows you to re-program buttons

on an i-fb01 remote control.

1. Enter the Menu and select System Config - Remotes - Edit.

2. EITHER Press the button you want to reprogram on the

remote control.

The display shows the identity and owner of the remote

control, and the button you pressed. Go to step 4.

OR If you do not have the remote control press >.

The display presents a list of the registered remote controls

and their users.

3. Press u or n to show the remote control you want to edit.

Press > to select it.

The display shows the first button on the remote control.

4. Press u or n to show the button you wish to re-program,

followed by > to select it.

Now that you have selected the button you wish to re-

program the display shows you the first of three options:

a) Set/unset some part of the system (see Set/Unset below).

b) Operate one of the outputs (see Operate an Output on

page 28) If you cannot see this option on the display then

the installer has not made any outputs available for users.

c) Do nothing (disable the button).

5. Press u or n followed by > to select the option you wish to

use.

Set/Unset

If you selected Set/Unset in step 5 above:

The bottom line of the display shows either “Set” or “Unset”.

A “*” at the beginning of the line shows the option currently

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sem comentários

Cooper Security i-on40 Manual do Utilizador Página 31