Cooper Security i-on40 Manual do Utilizador descarregar pdf (Página 34)

Administration i-on40

Page 30

Downloader. Your alarm system is programmed to call two

different telephone numbers. You do not have to know these

numbers, your Installer will tell you to select one of them.

To start the call:

1. Enter the User Menu and select System Config - Call Downloader.

The display shows the Call to Downloader menu.

2. Select Telephone Number 1 or 2, or IP Address 1 or 2 as

instructed by your installer.

The control unit calls the installer's computer on the number

you selected.

Your system may be connected to Downloader for several

minutes.

When Downloader has finished and the connection is broken

the display shows the time and date.

Redirecting Speech Messages

Note: This option appears only if you have the a speech dialler

module fitted inside the control unit.

If you need to re-direct speech messages to new telephone

numbers then:

1. Enter the Menu and select System Config - Speech Phone Book.

The bottom line of the display shows “Tel No 1”.

2. Press u or n to scroll through the available telephone

numbers, followed by > to gain access to an individual

number.

The bottom line of the display shows the current digits of the

telephone number.

3. Key in the new telephone number from the keypad. If

necessary, press u to move the cursor left, or n to move

the cursor to the right. Press < to remove digits to the left of

the cursor.

4. Press Y to store the changes you have made.

1 2 ... 29 30 31 32 33 34 35 36

Sem comentários

Cooper Security i-on40 Manual do Utilizador Página 34