Cooper Security i-on40 Guia de Instalação descarregar pdf (Página 64)

Installer Mode Programming i-on40

Page 60

The values available are 0 to 10 minutes. Note that when

the value is set to 0 minutes, mains interruptions of less

than 9 seconds will not start an alert.

Communications

Note: If you have connected a plug-by communicator

then use the Outputs - Plug-by Outputs menu to

program the communicator.

The Communications option in the Installer Menu contains

all the options needed to program how the control unit

will communicate alarms. Within the Communications

option, the main menu items deal with the following

areas:

ARC Reporting

Deals with reporting to a central station using either

SIA, CID or Fast Format.

Speech Dialler

Deals with recording speech messages, selecting the

alarm types that will trigger them, and selecting

destinations for the messages. This sub-menu is

visible only when the i-sd02 or i-gsm-2 modules are

fitted.

SMS

Deals with setting up text messages, selecting the

alarm types that will trigger them an selecting their

destinations. This sub-menu is visible only when the

i-sd02 or i-gsm-2 modules are fitted.

Line Fail Reporting

Allows you to select how the control unit reports a

communications failure.

IP Network (Own)

The Web Server sub-menu deals with setting the

control unit’s own IP address and access to the built

in web-pages.

The other sub-menus within IP Network (Own) menu

allow you to set up the IP address and other

parameters for any attached Ethernet or GPRS

modules. These sub-menus will not appear if the

modules are not fitted.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 115 116

Sem comentários

Cooper Security i-on40 Guia de Instalação Página 64