Cooper Security i-on40 Guia de Instalação descarregar pdf (Página 99)

i-on40

Page 95

Appendix I Installer Menu Defaults

Important: Where noted below the defaults listed enable

the control unit to comply with EN50131 requirements. If

you change these setting then the installation may no

longer comply. If the control unit does not comply with

EN50131 you must remove any labelling that indicates

compliance.

DETECTORS/DEVICES

ZONES 1 - 40

Name: “Zone nn”

Type: Not used

Partitions: Partition 1

Attributes:

Chime: No

Soak Test: No

Double Knock: No

Part Set B: No

Part Set C: Yes

Part Set D: Yes

Part Set: No

Omittable: No

Force Set Omit: No

WIRED/RADIO KEYPADS

Name: “KP0n” or “RKP0n”

Partitions: Partition 1 - 4

Key A:

Name: “Key A”

Action: Partition 1 Full Set

OR Full Set

Key B:

Name: “Key B”

Action: Partition 2 Full Set

OR Part Set B

Key C:

Name: “Key C”

Action: Partition 3 Full Set

OR Part Set C

Key D:

Name: “Key D”

Action: Partition 4 Full Set

OR Part Set D

EXTERNAL SIREN 1 - 4:

Partition 01

INFO MODULES

Updates: Disabled

Rdy to set LEDs: Disabled

OUTPUTS

All outputs allocated to all partitions.

RADIO OUTPUTS 1 - 8

Name Type Polarity

Output 1-8 Not Used Normal

WIRED OUTPUT 1 - 4

Name Type Polarity

Output 1 Siren Normal

Output 2 Strobe Normal

Output 3 Siren Normal

Output 4 Strobe Normal

PLUG BY OUTPUT 1 - 12

Name Type Polarity

Output 1 Fire Normal

Output 2 Panic Alarm Normal

Output 3 Burglar Alarm Normal

Output 4 Open / Close Inverted

Output 5 Omit (System) Normal

Output 6 Alarm Abort Normal

Output 7 Confirmed Normal

Output 8 Technical Normal

Output 9 Panel AC Fail Normal

Output 10 Panel Batt FaultNormal

Output 11 General Fault Normal

Output 12 Tamper Normal

PART SETTING OPTIONS

FULL SET

Name: “Full Set”

Exit Mode: Timed Set

PART SET B, C AND D

Exit Mode: Instant Set

Alarm Response: Internal+Siren

Part Set Final Exit: Final exit

Part Set Entry Route: Entry Route

PART SET B NAME:

“Part Set B”

PART SET C NAME:

“Part Set C”

PART SET D NAME:

“Part Set D”

EXIT TIME:

40s

(See Note 2)

ENTRY TIME:

45s

Note: The maximum time permitted by

EN50131-1 Clause 8.3 is 45 seconds.

STROBE ON SET:

Disabled

(See Note 2)

STROBE ON UNSET:

Disabled

PARTITIONS 01 - 02

Name: “Partition 1”

Exit Mode: Timed Set

Exit Time: 45

Entry Time: 45

Note: The maximum time permitted by

EN50131-1 Clause 8.3 is 45 seconds.

Alarm Response: Siren + Comms

Part Set Exit Mode: Instant Set

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 115 116

Comentários a estes Manuais

Sem comentários

Cooper Security i-on40 Guia de Instalação Página 99

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on40