Cooper Security i-on160EX Guia de Instalação descarregar pdf (Página 103)

i-on160 Installer Menu Options

Page 97

IP Address This is the IP address the control unit uses when linked by

Ethernet to a PC.

Subnet Mask This is the subnet mask currently in use by the control unit

itself.

Gateway Address

his is the

ateway address bein

used by the control unit.

MAC Address This is the unique MAC address of the control unit pcb.

Each control unit pcb will have an individual MAC address.

IP Link Status This option shows the current status of the Ethernet link

between a PC and the control unit. The display shows “Fail”

when there is no link, and “OK” when the Ethernet link is

established. Note that “OK” only shows that the link is

established, it does not show that the PC is logged into the

control unit.

Module: Shows the identity of the communications module currently fitted.

Zone Mapping

This option allows you to check which zones are currently allocated to detector

connection points, or which detector connection points have zone numbers

allocated. There are two options:

Zone Number

The display shows a list of zone numbers (with names), with detector

connection points for each zone.

Zone address

The display shows a list of detector connection points, with zone numbers

and names, where allocated.

Non-Programmable Functions

Alarm Abort

The i-on160EX contains a fixed Alarm Abort Delay period of 90 seconds. The

control unit starts the Alarm Abort Delay timer whenever it starts an alarm. If

a user silences the alarm within the Abort Delay period, the alarm will not

require an engineer or remote reset.

If an alarm occurs and a user unsets the system within the Alarm Abort Delay

period then the control unit activates any output of type Alarm Abort (page 46)

and starts any Alarm Abort Fast Format communications programmed.

Remote Reset (RedCare Reset)

If the system is configured for installer reset only (you have programmed

option System Options – User Reset – Zone alarms as “No” or System Options - DD243

- Confirmation is “On”) then the control unit enables the Remote Reset input pin

on the its plug by connector. After an alarm, the user can silence the sounders

but must contact an Alarm Receiving Centre (ARC) to reset the system.

The ARC verifies the user’s identity and (provided that the control unit is fitted

with a suitable plug-by communicator) can send a +12v signal to the remote

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Guia de Instalação Página 103

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX