Cooper Security i-on160EX Guia de Instalação descarregar pdf (Página 79)

i-on160 Installer Menu Options

Page 73

Note: Apart from Downloading and IP Network (Own), the above menu items

appear only if the appropriate module is fitted.

The control unit is designed to alert the user if it fails to complete a

programmed communication. If alarm reporting fails then the keypad displays

an alert by lighting the red LEDs around the navigation keys. Although the user

may acknowledge the alert, the control unit will not remove the alert until

communication is completed successfully.

If you wish to remove a communications module from a system, ensure that

you first disable communications in the appropriate menus:

To remove a: Disable:

i-sd02, i-gsm02 ARC Reporting, Speech Dialler, SMS

GPRS, Ethernet ARC Reporting, IP Network

Otherwise the control unit will continually report a communications failure.

ARC Reporting

To program how the control unit will communicate with an ARC select

Communications - ARC Reporting.

Call Mode

To choose the call mode for communicating with an ARC select: Communications

– ARC Reporting – Call Mode. The call modes available are:

Disabled.

The control unit disables all ARC communications.

Note: If you have fitted an 8750 module to the control unit then the module

will continue to send Poll calls to the ARC even if you set call mode to

disabled. (The ARC will not receive alarm or test calls.) If you also

disconnect the Ethernet cable from the 8750 module the control unit will

not raise a Line Fail or Poll Fail alert, because you have set the call mode

to disabled.

Single.

The control unit reports to the first telephone number in the Phone Book,

using a single account number (see "Account Numbers" on page 74).

Operation: The control unit dials the number and attempts to connect with

the ARC. If the call fails, the control unit ends the call and then re-

attempts to connect up to a maximum of 15 times.

Alternate.

The control unit reports to one of the two telephone numbers in the Phone

Book.

Operation: The control unit dials the first telephone number and attempts

to connect to the ARC. If it fails, it will then close down and dial the

second telephone number and attempt to connect to the ARC. If received

and acknowledged on this attempt, the alarm transmission is complete. If

the control unit fails to connect to the second telephone number, it will

close down again and re-attempt to connect to the first telephone

number. The control unit will continue to shuttle between the two

numbers up to 15 times.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Guia de Instalação Página 79

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX