Cooper Security i-on160EX Guia de Instalação descarregar pdf (Página 84)

Installer Menu Options i-on160

Page 78

Downloading failed - RU

*Notes:

1. The control unit communicates Jamming, Supervision

when the system is unset.

Restorals

When you enable a CID/SIA Report Group, the control unit sends the relevant

telegram both when an event occurs, and when the condition causing the

event stops. The second transmission of the telegram is also called a “restore”.

You can enable or disable restoral reporting by selecting Communications – ARC

Reporting – Restorals. The options available are:

Disabled

Restore off. The control unit does not communicate restores.

Enabled.

Restore on. The control unit does communicate restores.

Burg Comms Rearm

(This menu appears only if you select “Fast Format” in Communications - Report

Type.) This menu option determines what the control unit does with the “Burg”

Fast Format channel 3 at the end of the siren run time. There are two options:

Disabled

The channel stays active until an Installer or user resets the system.

Enabled

The system rearms Channel 3 once the siren timer has expired. Once the

Channel is rearmed, the system is ready to report any new alarm. The

system bypasses any detectors that are still triggered.

Notes:

If a Final Exit Zone is triggered, Channel 3 becomes active at the end of

the Programmed Entry time.

21CN FF Ack Time

(This menu appears only if you select “Fast Format” in Communications - Report

Type.)

A PSTN line connected to a BT21CN line (or equivalent) will take longer to

acknowledge a Fast Format transmission. This option allows you to adjust the

length of time that the control unit waits for the ARC acknowledgement. You

can adjust the acknowledgement time from a minimum of 400ms up to a

maximum of 1200ms in 100ms steps.

Send Tamper as Burg

When using CID reporting this option allows you to program the control unit to

send tampers as alarm.

If you select Disabled, (the default) then the control unit sends all CID

messages as specified in Communications – ARC Reporting – CID/SIA Events.

If you select Enabled then for full alarm response the control unit sends

tampers as burglary (BA) and sends Contact ID 130 in place of Contact ID 137.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Guia de Instalação Página 84

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX