Cooper Security i-on160EX Guia de Instalação descarregar pdf (Página 76)

Installer Menu Options i-on160

Page 70

Entry Alarm Delay

Use this option to determine what the system will do if a user strays from an

Entry Route zone during entry. (This option is available to provide compliance

with EN 50131-1.)

Select “No” to make the system give an alarm immediately if the user strays

from an entry route zone during entry. Note: This is not compliant with

EN50131.

If you select “Yes” and the user strays from an entry route zone during entry

then the system waits 30 seconds before raising a full alarm. The system also

gives an internal alarm during the 30 second wait.

If the user enters an access code or presents a tag before the end of the 30

seconds internal alarm then the user can reset the system.

Supervision

If a wirefree detector loses contact for more than 20 minutes then the control

unit logs the event as “RF Warning”. In addition, the control unit inhibits

setting. If a user overrides the inhibition then the control unit logs the event as

an RF warning override.

If a wirefree detector loses contact for more than two hours then the control

unit raises an alarm. The options available for this alarm are:

Option: With system SET, the

control unit:

With system UNSET the

control unit:

Disabled Does nothin

. Does nothin

Fault Logs the event (but does NOT

display any alert or fault

tone).

Displays an Alert and sounds a

fault tone and logs the event.

Jamming

The control unit can detect interfering (or "jamming") radio signals. To enable

jamming detection select System Options - Jamming.

If the control unit detects jamming once you have enabled this option then the

display shows an Alert message for the user.

Force Set

You may wish to allow a user with a remote control to set the alarm system

when one or more of the detectors are not working or are open (active).

Note: If you enable “Force Set” then the system does not comply with

EN50131.

There are three options available:

Off

The remote control user cannot force set the system, even if you have

applied the force set zone attribute to any zones.

Confirm

The remote control user can force set the system. They must operate as

follows: 1) the user presses the appropriate button to set the system, 2)

the control unit does not start setting, 3) the user presses the same

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Guia de Instalação Página 76

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX