Cooper Security i-on160EX Guia de Instalação descarregar pdf (Página 72)

Installer Menu Options i-on160

Page 66

On a Security Grade 2 system the ability to reset the alert is

governed by the System Options - User Reset - System Tampers option,

see page 62.

When the system is set:

Detector

output

Response

Mask

(9k1)

The control unit treats a masking event as an alarm condition.

This will signal an unconfirmed alarm or will confirm an

outstanding unconfirmed alarm. The unconfirmed and confirmed

events must be from different detectors.

The ability to reset the system after the alarm is governed by the

System Options - User Reset – Zone Alarms option, see page 61.

Fault

(4k4)

The control unit treats a masking event as a fault, activates any

outputs programmed as General Fault or Masking, and generates

an Alert on the keypads.

On a Security Grade 3 system the Installer must reset the Alert.

On a Security Grade 2 system the ability to reset the alert is

governed by the System Options - User Reset - System Tampers option,

see page 62.

Mask Override

This option controls how the user can respond to a masking event once it is

reported by the control unit. There are two options:

Mask

Override

A User can override a masking fault to set the system

Mask

Inhibit

Set

A User is may not override a maskin

fault to set the system. The

system will not set until the masking fault has cleared.

Language

The control unit can use one of several languages in its display. To change the

language select System Options – Language.

Changing the language does not affect any stored names for full/part set,

detectors, outputs or users, and does not change any defaults.

Restore Defaults

Country Defaults

Each country has different settings for PSTN communications and alarm

reporting. You can use this option to select default settings for a given country.

Changing the country does not change the language used by the display.

Staged Defaults

This menu option allows you to default parts of the control unit’s programming,

without affecting the whole system. From within this menu you can choose to

default one or more of the following:

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Guia de Instalação Página 72

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX