Cooper Security i-on160EX Guia de Instalação descarregar pdf (Página 40)

Installer Menu Options i-on160

Page 34

Normal Alarm (03).

When triggered, a zone programmed as ‘Normal Alarm’ will start an alarm

provided the system is set.

When the control unit first learns a radio detector the zone type defaults

to Normal Alarm.

24 Hour Alarm (04).

Activating this zone causes an internal alarm (keypads and speakers)

whether the system is set or unset.

Final Exit (05).

Zones of this type must be the last detector to be activated on exit, or the

first to be activated on entry. You can use zones of this type to finally set

the system or partition, or to start the entry procedure. See page 54 to

set the exit mode type.

Note: If you give a Final Exit zone any of the Part Set attributes then you can

program that zone to behave like a Normal Alarm zone if the user part

sets the system. See page 55 .

Entry Route (06).

Use this zone type for detectors sited between the Final Exit door/detector

and the keypad. If an ‘Entry Route’ zone is triggered when the system is

set, an alarm will occur. If the entry/exit timer is running when an Entry

Route zone is triggered then no alarm occurs until the entry/exit timer

expires.

Note: If you give an Entry Route zone one of the Part Set attributes then you

can program that zone to behave like a Final Exit zone if the user part

sets the system. See page 55 .

Technical Alarm (07).

Use this zone type when you want to monitor equipment, for example a

freezer, without raising a full alarm. If a technical alarm zone is activated

then the control unit logs the event and (if the control unit is correctly

programmed, see page 72) starts communication.

If the technical alarm occurs while the system is set, then system makes

no audible alarm. When a user unsets the system the keypad shows an

alert.

If a technical alarm zone is activated while the system is unset then the

system starts an alert immediately and gives a brief tone from the keypad

every few seconds. When a user enters a valid access code the keypad

stops the tone and displays the zone causing the alarm.

When the user acknowledges the alert by pressing Y the control unit

resets the technical alarm ready for the next event.

Key Switch Momentary (08).

Use this zone type to connect a momentary keyswitch to a single zone.

In a Part Setting system the keyswitch can Full Set or unset.

In a Partitioned system you can allocate the keyswitch to one or more

partitions.

Each time a user operates the keyswitch the control unit changes the

current set state.

Key Switch Latched (09).

Use this zone type to connect a fixed position keyswitch to a single zone.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Guia de Instalação Página 40

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX