Cooper Security i-on160EX Guia de Instalação descarregar pdf (Página 58)

Installer Menu Options i-on160

Page 52

In the Installer Menu, while programming a user output type, the control unit

gives you the following options:

Polarity

Polarity can be either Normal or Inverted. This option works the same way

as described for Wired Outputs – see page 45.

Latched

Latched can be either Yes or No.

No: The output initially changes state when a user operates the output,

but then changes state again after a set time. The time is fixed by the “On

Time” option, below.

Yes: The output changes state every time a user operates the output. In

addition, three new menu options appear that allow you to set an On time

and Off time for any day of the week, see below.

On Time

If you select Latched = No, then use this option to key in the number of

seconds the output should remain active. You can select any period

between 1 and 999 seconds. Note that if you select an active time of zero

seconds then the output will not operate.

On Time/Off Time/Days

If you select Latched = Yes, then use these three options to make a user

defined output come on and go off in a regular pattern.

On Time: Key in the time on the 24 hour clock when you want the output

to activate.

Off Time: Key in the time on the 24 hour clock when you want the output

to deactivate.

Days: Select one or more days of the week when you want the output to

operate.

The control unit will operate the output at the times selected. However, if

a user activates the output while it is Off, then the output stays on until

the control unit reaches the next Off time. If a user de-activates the

output while it is On, then the output stays off until the control unit

reaches the next On time.

If you do not key any values into On Time/Off Time/Days, then the output

acts as a simple On/Off switch under control of the user.

“Setting Options” and “Partitions” Menus

Part Setting or Partitioned System?

When you first power-up a new i-on160EX (see i-on160EX Installation Guide ),

or if you restore an i-on160EX control unit to factory defaults (see page 67 ),

you must choose between having a Part Setting system or a Partitioned

system.

If you select a Part Setting system then the Installer Menu contains a “Setting

Options” sub menu. If you select a partitioned system then the installer menu

contains “Partitions” sub-menu instead.

Both of these menus contains the same options, but organised in slightly

different ways:

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 179 180

Comentários a estes Manuais

Sem comentários

Cooper Security i-on160EX Guia de Instalação Página 58

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Cooper Security i-on160EX